24/7 online - 
1-316-444-1378 or 44-141-628-6690
Login
Write a code in MatLAB where input message signal is your name and surname: “Name” “Surname”. The signal sampling frequency will be 1 MHz, the carrier frequency will be 100 kHz and the number of samples per bit will be 20. The cut off frequency of the filter will be 25 kHz.Run the code generated […]
Archive for the ‘Telecommunication Engineering’ Category
QPSK Modulation and Demodulation without consideration of noise
August 24th, 2020 
Posted in Graduate, Telecommunication Engineering 
Comments Off on QPSK Modulation and Demodulation without consideration of noiseMatlab PAM PWM PPM sketch
July 14th, 2020 Matlab implementation:1. Assume the train of pulses frequency and any other required parameters.2. Use a single tone signal as a modulating signal. Plot this signal in time domain and plot its frequency spectrum.3. Plot the modulated signal (PAM, PWM and PPM) in time domain and its frequency spectrum.
Implementing network using packet tracer
July 5th, 2020 Hi, I am having some difficulty and not being able to figure it out how to Add a default static route on Home Router so that it will deliver all packets correctly. ( What IP should I be using)Add a static route to 44.1.1.0/24 on SF router.I have attached the Cisco Packet Tracer and highlight […]
Posted in Telecommunication Engineering, Undergraduate Comments Off on Implementing network using packet tracer